Cma-dishmachines GL-X Instrukcja Użytkownika

MODEL GL-X INSTALLATION & OPERATION Rev. 1.01 800-854-6417 FAX 714-895-2141 Owner’s Manual Keep with machine for reference CMA DISHMAC

Operation These cams were set at the factory but must be adjusted after final installation to maximize efficiency of chemical use (see section 4.1.1

Maintenance 4. Maintenance The maintenance procedures detailed in this section are to be p

Maintenance 4.2. Quick service guide MODELS: GLX TECHNICAL ISSUE CAUSE SOLUTION Delimer switch in delime position Flip to NORMAL position

Maintenance 4.3. Troubleshooting PROBLEM LIKELY CAUSE SOLUTION Power off at circuit breaker Reset circuit breaker Defective power switch Replac

Maintenance PROBLEM LIKELY CAUSE SOLUTION Turn up supply water heater Low incoming water temperature (below 140° F) Insulate supply water pipe The

Maintenance PROBLEM LIKELY CAUSE SOLUTION Defective sani/detergent primer switch Replace primer switch P/N: 03470.00Activating detergent primer sw

Addendum 5. Addendum for Machines Installed in the City of Chicago “Al

Appendix A: Operator & Cleaning Instructions MODEL GL-X INSTALLATION & OPERATION MANUAL Rev. 1.01 –08/04/05

Electrical Diagram 6. Electrical Diagra

Electrical Diagram J7J6J5WASH TANKINDICATORTEMPERATURE SENSORWIRE DIAGRAM FOR MODEL: GL-X09/06/05DELIMENORMALDOORSAFETYSWITCHCYCLELIGHTPOWERLIGHTRev.

TABLE OF CONTENTS MODEL CMA-GL-X 1. SPECIFICATIONS...2 1.1. GL

1. Specifications METRIC EQUIVALENT 1.1. GL-X WATER CONSUMPTION PER RACK 1.7 GAL. 6.44 L PER HOUR 40.8 GAL. 154.4 L OPERATING CYCLE WASH

1.2. GL-X Operational Cycle The GL-X Operational Cycle has a total cycle time of 2 minutes (120 seconds). The Timing Diagram and the steps listed b

The pump motor runs the pump for the 57-second wash cycle, then pumps the water out through the drain, turns off for about 8 seconds (allowing the ma

Getting Started 2. Getting Started 2.1. Introduction to the GL-X The GL-X Glasswasher is unique in its field; it has all the features of a standar

Getting Started 2.2. Receiving and Installation The glasswasher is shipped from the factory in a corrugated box on a wooden pallet. The installatio

Getting Started 2.2.4. Installers Checklist  Glasswasher checked for concealed damage  Hot water supply is recommended 140° F (60 C)  Incomi

Operation 3. Operation 3.1. Initial Setup 3.1.1. Check…  Drain screen is in place  Spay arms and end plugs are secure 3.1.2. Chemicals • Assure